ZyXEL Communications ZYWALL 5 - System Statistics

ZyWALL 5 User’s Guide
Chapter 2 Introducing the Web Configurator 65
2.4.4 System Statistics
Click Show Statistics in the HOME screen. Read-only information here includes port status
and packet specific statistics. Also provided is "Up Time" and "poll interval(s)". The Poll
Interval(s) field is configurable.
SSH Use this screen to configure through which interface(s) and from
which IP address(es) users can use Secure Shell to manage the
ZyWALL.
TELNET Use this screen to configure through which interface(s) and from
which IP address(es) users can use Telnet to manage the
ZyWALL.
FTP Use this screen to configure through which interface(s) and from
which IP address(es) users can use FTP to access the ZyWALL.
SNMP Use this screen to configure your ZyWALL’s settings for Simple
Network Management Protocol management.
DNS Use this screen to configure through which interface(s) and from
which IP address(es) users can send DNS queries to the ZyWALL.
UPnP UPnP Use this screen to enable UPnP on the ZyWALL.
Ports Use this screen to view the NAT port mapping rules that UPnP
creates on the ZyWALL.
LOGS View Log Use this screen to view the logs for the categories that you
selected.
Log Settings Use this screen to change your ZyWALL’s log settings.
Reports Use this screen to have the ZyWALL record and display the
network usage reports.
MAINTENANCE General This screen contains administrative.
Password Use this screen to change your password.
Time and Date Use this screen to change your ZyWALL’s time and date.
Device Mode Use this screen to configure and have your ZyWALL work as a
router or a bridge.
F/W Upload Use this screen to upload firmware to your ZyWALL
Configuration Use this screen to backup and restore the configuration or reset
the factory defaults to your ZyWALL.
Restart This screen allows you to reboot the ZyWALL without turning the
power off.
LOGOUT Click this label to exit the web configurator.
Table 5 Screens Summary (continued)
LINK TAB FUNCTION