ZyWALL 5 User’s Guide
Appendix Q Log Descriptions 655
Log Commands
Go to the command interpreter interface. Appendix K on page 619 explains how to access and
use the commands.
Configuring What You Want the ZyWALL to Log
1 Use the sys logs load command to load the log setting buffer that allows you to
configure which logs the ZyWALL is to record.
2 Use sys logs category to view a list of the log categories.
Figure 71 Displaying Log Categories Example
3 Use sys logs category followed by a log category to display the parameters that are
available for the category.
KE Key Exchange
ID Identification
CER Certificate
CER_REQ Certificate Request
HASH Hash
SIG Signature
NONCE Nonce
NOTFY Notification
DEL Delete
VID Vendor ID
Table 55 RFC-2408 ISAKMP Payload Types (continued)
LOG DISPLAY PAYLOAD TYPE
ras> sys logs category
8021x access attack display
error icmp ike ipsec
javablocked mten packetfilter ppp
cdr pki tls remote
tcpreset traffic upnp urlblocked
urlforward wireless
To Next Page
Loading...
