ZyWALL 5 User’s Guide
Chapter 38 Firmware and Configuration File Maintenance 497
Figure 309 Backup Configuration Example
Type a location for storing the configuration file or click Browse to look for one.
Choose the Xmodem protocol.
Then click Receive.
4 After a successful backup you will see the following screen. Press any key to return to the
SMT menu.
Figure 310 Successful Backup Confirmation Screen
38.4 Restore Configuration
This section shows you how to restore a previously saved configuration. Note that this
function erases the current configuration before restoring a previous back up configuration;
please do not attempt to restore unless you have a backup configuration file stored on disk.
FTP is the preferred method for restoring your current computer configuration to your
ZyWALL since FTP is faster. Please note that you must wait for the system to automatically
restart after the file transfer is complete.
Note: WARNING!
Do not interrupt the file transfer process as this may PERMANENTLY
DAMAGE YOUR ZyWALL. When the Restore Configuration process is
complete, the ZyWALL will automatically restart.
38.4.1 Restore Using FTP
For details about backup using (T)FTP please refer to earlier sections on FTP and TFTP file
upload in this chapter.
** Backup Configuration completed. OK.
### Hit any key to continue.###
To Next Page
Loading...
