ZyWALL 5 User’s Guide
Chapter 31 Remote Node Setup 433
31.3.2 PPPoE Encapsulation
The ZyWALL supports PPPoE (Point-to-Point Protocol over Ethernet). You can only use
PPPoE encapsulation when you’re using the ZyWALL with a DSL modem as the WAN
device. If you change the Encapsulation to PPPoE, then you will see the next screen. Please
see
Appendix D on page 563 for more information on PPPoE.
Server This field is valid only when RoadRunner is selected in the Service Type field. The
ZyWALL will find the RoadRunner Server IP automatically if this field is left blank. If
it does not, then you must enter the authentication server IP address here.
Relogin Every
(min)
This field is available when you select Telia Login in the Service Type field.
The Telia server logs the ZyWALL out if the ZyWALL does not log in periodically.
Type the number of minutes from 1 to 59 (30 recommended) for the ZyWALL to wait
between logins.
Route This field refers to the protocol that will be routed by your ZyWALL – IP is the only
option for the ZyWALL.
Edit IP This field leads to a “hidden” menu. Press [SPACE BAR] to select Yes and press
[ENTER] to go to Menu 11.1.2 - Remote Node Network Layer Options.
Session Options
Schedules You can apply up to four schedule sets here. For more details please refer to
Chapter 41 on page 519.
Edit Filter Sets This field leads to another “hidden” menu. Use [SPACE BAR] to select Yes and
press [ENTER] to open menu 11.1.4 to edit the filter sets. See
Section 31.5 on page
438 for more details.
Edit Traffic
Redirect
Press [SPACE BAR] to select Yes or No.
Select No (default) if you do not want to configure this feature. Select Yes and press
[ENTER] to configure Menu 11.6 - Traffic Redirect Setup.
Once you have configured this menu, press [ENTER] at the message “Press ENTER to Confirm...” to
save your configuration, or press [ESC] at any time to cancel.
Table 168 Menu 11.1: Remote Node Profile for Ethernet Encapsulation (continued)
FIELD DESCRIPTION
To Next Page
Loading...
