ZyWALL 5 User’s Guide
Chapter 6 Wireless LAN 119
6.11.8 No Access 802.1x + No WEP
Select No Access 802.1x + No WEP to deny all wireless stations access to your wired
network and block all wireless stations from communicating with the ZyWALL.
6.12 Configuring MAC Filter
The MAC filter screen allows you to configure the ZyWALL to give exclusive access to
specific devices (Allow Association) or exclude specific devices from accessing the
ZyWALL (Deny Association). Every Ethernet device has a unique MAC (Media Access
Control) address. The MAC address is assigned at the factory and consists of six pairs of
hexadecimal characters, for example, 00:A0:C5:00:00:02. You need to know the MAC
addresses of the devices to configure this screen.
To change your ZyWALL’s MAC filter settings, click WIRELESS LAN, then the MAC
Filter tab. The screen appears as shown.
Figure 42 MAC Address Filter
To Next Page
Loading...
