ZyWALL 5 User’s Guide
Chapter 7 WAN Screens 141
Dial Timeout (sec) Type a number of seconds for the ZyWALL to try to set up an outgoing call before
timing out (stopping).
Retry Count Type a number of times for the ZyWALL to retry a busy or no-answer phone
number before blacklisting the number.
Retry Interval
(sec)
Type a number of seconds for the ZyWALL to wait before trying another call after a
call has failed. This applies before a phone number is blacklisted.
Drop Timeout
(sec)
Type the number of seconds for the ZyWALL to wait before dropping the DTR
signal if it does not receive a positive disconnect confirmation.
Call Back Delay
(sec)
Type a number of seconds for the ZyWALL to wait between dropping a callback
request call and dialing the corresponding callback call.
Apply Click Apply to save your changes back to the ZyWALL.
Cancel Click Cancel to exit this screen without saving.
Table 41 Advanced Setup (continued)
LABEL DESCRIPTION
To Next Page
Loading...
