Installation Guide for the 2GIG EDGE Security Panel
28
Panel Programming – Wireless Zones
You can program up to 100 wireless zones per system. To get started, tap Wireless Zones to view the Wireless Zones screen.
Selecting a Wireless Zone
1. On the left side of the Wireless Zones screen, swipe up or down to scroll
the list of zones.
2. Tap and highlight one of the available zones.
3. Tap EDIT ZONE to view settings for the selected zone.
Equipment Code
1. Tap Equipment Code.
2. Tap
≡
to expand the list.
3. Tap to select the desired equipment code from the list.
4. Tap to move to the next option.
Sensor Type
1. Tap Sensor Type.
2. Tap
≡
to expand the list.
3. Tap to select the appropriate sensor type from the list.
NOTE: You can also use the keypad to enter the two-digit
code to display a Sensor Type.
4. Tap to move to the next option.
Sensor Equipment Type (if needed)
If you selected 04-Interior Follower, 06-24-Hour Silent Alarm, 07- 24-Hour Audible Alarm, 24-Hour Auxiliary Alarm, 10-Interior with Delay, 23-No Response
Type
in “Sensor Type" above, you must also select this option (continued next page).
5. Tap Panel Programming to view programming options (see below).
To Next Page
Loading...
Need help?
General
