26
2GIG EDGE User Guide
DISARMING THE SYSTEM
To turn the system’s burglary protection sensors OFF, you disarm the system. Disarming the system also silences any
type of alarm that might be sounding.
NOTE: To use this feature, you must have an active user code. See your system’s Master User to obtain a code.
Disarm the System (Stay Mode)
When the system is armed in Stay Mode, any person
with an active user code can disarm the system.
To disarm the system:
1. At the System Armed screen, tap DISARM.
TIP: If you want to exit the premises through one
of the Exit/Entry doors while the system is armed
in Stay Mode, tap the QUICK EXIT button. See
Use the Quick Exit Button on the previous page.
System Armed > Disarm Button
2. At the Enter your code to disarm the system
screen, enter an active user code.
The system is disarmed. If protected doors and windows
are closed, the system sounds the System Disarmed,
Ready to Arm announcement. If protected doors or
windows are open, the system sounds the System
Disarmed Not Ready to Arm announcement.
Enter Your Code to Disarm the System
Disarm the System (Away Mode)
When the system is armed in Away Mode, any person
with an active user code can disarm the system. You
must enter the code before the Entry Delay countdown
expires to avoid setting off the alarm.
To disarm the system from Away Mode:
1. Enter the premises using one of the Exit/Entry
doors. The system’s Entry Delay beeps sound.
NOTE: Consult your installer to determine how
the Entry Delay feature is congured on your
system (30-240 seconds).
2. At the Entry Delay screen, enter an active user
code. You must enter your code before the Entry
Delay countdown expires.
The system is disarmed. If protected doors and windows
are closed, the system sounds the System Disarmed,
Ready to Arm announcement. If protected doors or
windows are open, the system sounds the System
Disarmed Not Ready to Arm announcement.
Enter Your Code to Disarm the System
To Next Page
Loading...
Need help?
General
