EasyManuals Logo

2gig Technologies EDGE User Manual

2gig Technologies EDGE
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
30
2GIG EDGE User Guide
Transmit a Duress Signal when System is
Disarmed
To transmit a user duress report when the system is
disarmed:
1. At the Home screen or from one of the menus,
press and hold the 2GIG logo.
2. At the Keypad, enter the Duress Code.
The system will return to the Home screen, and the
duress signal is sent to the Central Station.
NOTE: See Activate the Duress Code, page 52,
for Duress Code activation instructions.
System Logo
Enter the Duress Code
In the Event of a Burglary Alarm
If one or more armed sensors are tripped while the
system is armed in Stay or Away Mode, an alarm
condition will occur, and the system’s alarm siren will
sound.
If an Entry Delay sensor is tripped while the system
is armed in Stay or Away Mode, the Entry Delay
countdown starts to give you time to disarm the system.
If the system is not disarmed before the countdown
expires, an alarm condition occurs, and the system’s
alarm siren will sound.
If more than one armed sensor is tripped, the system
displays the triggered sensors in chronological order.
Alarms Screen—Multiple Alarms in Chronological Order
Silencing the Alarm Sounder (for False Alarms)
If the system is in an active alarm state, any person with an active user code can silence the sounder by disarming the
system.
»
If you disarm the system BEFORE the Abort Window Dialer Delay countdown expires, the system
cancels the alarm and stops the alarm report from being transmitted to the Central Station.
»
If you disarm the system AFTER the Abort Window Dialer Delay countdown expires, the system
silences the alarm and transmits an alarm cancellation report to the Central Station.
NOTE: Consult your installer to determine how the Alarm Abort Window Dialer Delay feature is congured on
your system (15-45 seconds). This setting species the number of seconds end users have to manually abort
the alarm, in the event of a false alarm. For ANSI/SIA CP-01-2010 compliance, the default setting is 30 seconds.
For UL 1023: Household Burglar Alarm Units compliance, this setting may be congured to a maximum of 45
seconds.

Table of Contents

Other manuals for 2gig Technologies EDGE

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the 2gig Technologies EDGE and is the answer not in the manual?

2gig Technologies EDGE Specifications

General IconGeneral
Brand2gig Technologies
ModelEDGE
CategorySecurity System
LanguageEnglish

Related product manuals