54
2GIG EDGE User Guide
Smart Home Settings
Refer to the 2GIG EDGE Smart Home manual.
Bypass Sensors
You can manually bypass a sensor using the Bypass
Sensors button( ) in the System Settings menu.
When you need to bypass one or more perimeter or
interior sensors, it is most common to manually bypass
the sensor. There is also an alternate method for
bypassing a sensor called Force Bypassing. See Force
Bypassing, pg. 23.
NOTE: To use this feature, you must know the
Master User Code.
Manually Bypassing a Sensor
When manually bypassing a sensor, tap the Bypass
Sensors option in the System Settings menu to add
the desired sensors to the Bypassed Sensors list.
WARNING!! A bypassed burglary protection
sensor does NOT provide security protection
when the system is armed.
1. Enable the Bypass option(s) to bypass selected
sensors.
2. Press the back button (
).
The system is now ready to arm with selected sensors
bypassed. The system bypasses the devices and its
status changes to Ready To Arm (BYPASS).
After the system is disarmed, bypassed sensors are
automatically removed from the system’s Bypassed
Sensors list, unless the Auto Bypass for Manual
Bypass feature is enabled.
NOTE: Consult your installer to determine if
the Auto Bypass for Manual Bypass feature is
enabled.
Bypass Sensors
Ready to Arm (Bypass)
Removing Sensors from Bypassed Sensors List
After the system is disarmed, bypassed sensors are
automatically removed from the system’s Bypassed
Sensors list, unless the Auto Bypass for Manual
Bypass feature is enabled. If you decide you want to
remove a sensor from the Bypassed Sensors list before
you arm the system, use the steps detailed here.
To remove a sensor from the Bypassed Sensors list:
1. At the System Settings screen, tap Bypass
Sensors.
2. Move the slide control to the left for the desired
sensor. This removes the sensor from the
system’s Bypass Sensors list.
3. Tap when nished.
Remove Bypass Sensors
To Next Page
Loading...
Need help?
General
