33
Copyright © 2021 Nortek Security & Control LLC
2. Review the Alarms list. Then tap CLEAR
ALARM HISTORY.
Alarms Screen
Emergency Features
24-Hour Alarm Buttons
Three 24-hour alarm buttons can be shown or hidden by
the installer on the Control Panel’s touchscreen: Panic,
Fire, and Emergency.
You can open the following screen by pressing the
button on the Control Panel:
24-Hour Alarm Buttons
Panic Button
When activated, the system immediately goes into the alarm state. Depending on how the system is congured, the
Control Panel emits a loud, patterned warning siren or sets off a silent panic alarm with no siren. The system also
transmits a police report to the Central Station.
NOTES:
1 Consult your installer to determine if the Police Emergency Key is congured to sound an audible alarm or a
silent panic alarm.
2 Consult your installer to determine if the 2-Way Voice feature is enabled on the system. If enabled, setting off
the Panic alarm gives operators at the Central Station the ability use the Control Panel’s built-in speaker and
microphone to converse with people on the premises.
3 Consult your installer to determine if the Silent Panic/Burglary Listen Only feature is enabled on the system.
If enabled, setting off the Panic alarm gives operators at the Central Station the ability to use the Control
Panel’s built-in microphone to listen. If the panic alarm is sent, the operator can only listen. For your
protection, the operator will not be heard at the panel.
Fire Button
When activated, the system immediately goes into the alarm state. The Control Panel emits a loud, patterned warning
siren that is in compliance with ANSI S3.41 Temporal-3 Fire Alarm Signal and continues to sound until the system is
disarmed (see Disarming the System, pg 26) or the Fire Bell Cutoff Time expires. The system also transmits a Fire
Report to the Central Station.
NOTES:
1 Consult your installer to determine how the Fire Bell Cutoff Time is congured on your system. The time
can be congured to last 4 minutes, 8 minutes, 12 minutes, 16 minutes, or Unlimited (no cutoff). The default
setting is four (4) minutes.
2 If Smart Areas is enabled the Fire Button will create a global alarm in all Smart Areas. The alarm must be
acknowledged/cleared in each Smart Area.
To Next Page
Loading...
Need help?
General
