2gig Technologies EDGE User Manual

31
Copyright © 2021 Nortek Security & Control LLC
To silence the alarm sounder:
1. When an Alarm is sounding, enter an active, user
code.
2. Depending on how quickly you enter your code,
one of the following occurs:
a. If you enter your code before the Abort
Window Dialer Delay countdown expires,
"Disarming Canceled an Alarm Before it was
Transmitted" will be displayed.
Enter Your code to Silence the Alarm Screen
b. If you enter your code after the Abort Window
Dialer Delay countdown expires and before
the Alarm Cancel Time expires, the following
message appears.
3. Tap OK to dismiss the notication message.
Clearing an Alarm
If an alarm occurs while you are away, the 2GIG EDGE Panel’s Piezo Sounder will sound for a preset amount of time
(as dened by the Burglary Bell Cutoff Time and/or the Fire Bell Cutoff Time). Upon entry, the system emits repeated
beeps to warn you that an alarm was set off while you were away.
NOTE: Consult your installer to determine how the Burglary Bell Cutoff Time and Fire Bell Cutoff Time is
congured on your system. The time can be congured to last 4 minutes, 8 minutes, 12 minutes, 16 minutes, or
Unlimited (no cutoff). The default setting for both features is four (4) minutes.
CAUTION! If the system emits fast, repeated beeps (instead of the typical Entry Delay beeps), proceed indoors
with extreme caution. For your safety, it is recommended that you immediately leave the premises, go to a
secure location, and then contact your local authorities for assistance. If you have any reason to believe an
intruder is present, do NOT enter the premises until the dwelling is deemed safe by local authorities.

2gig Technologies EDGE Specifications

General

Brand	2gig Technologies
Model	EDGE
Category	Security System
Language	English