Remote Control Devices
The installer can pair your system with one or more wireless key fobs to
give you the ability to arm/disarm your system from a remote location using
the key fob's buttons. The GC3 Security & Automation System can be
paired to work with a maximum of 32 wireless key fobs. Depending on
your individual needs, key fobs can also be configured by the installer to
activate specific alarms.
Operate the System with a Key Fob
The installer can configure each key fob to let you perform up to five (5)
remote functions:
Arm the System in Stay Mode
Arm the System in Away Mode
Disarm the System
Activate an Auxiliary Function
Activate an Alarm
Arming the System Using a Keyfob
You can arm the system in Stay or Away mode using a key fob that has
been paired with the system.
To arm the system in Stay Mode, press the Stay button on
the key fob for two (2)seconds.
To arm the system in Away Mode, press the Away button on
the key fob for two (2)seconds.
NOTE: Consult your installer to determine how your keyfob
is configured to work with the system. Depending on your key
fob's setting, it may or may not be configured to arm the
system in one or both of the above modes.
Disarming the System Using a Key Fob
To disarm the system, tap the Disarm button on the key fob for two (2)
seconds.
NOTE: Consult your installer to determine how your keyfob
is configured to work with the system. Depending on the
individual key fob settings, it may or may not be configured to
disarm the system.
Activating an Auxiliary Function
To activate an auxiliary function, tap the Auxiliary button on the key fob
for two (2)seconds.
NOTE: Consult your installer to determine how your keyfob
is configured to work with the system. Depending on the
individual key fob settings, it may be configured to set of an
external siren/sounder, control a lock, control a light, or used
to activate a different auxiliary function.
Activating an Alarm Using a Key Fob
To activate an emergency alarm, press and hold both the Away and
Disarm buttons on the keyfob for five (5)seconds.
NOTE: Consult your installer to determine what type of
alarm your keyfob is configured to activate. Depending on
the individual key fob settings, this function might be disabled
on your key fob, or it might be configured to activate an
auxiliary, audible, or silent panic alarm.
NOTE: In order to cancel an emergency alarm activated with
a key fob, you must disarm the system at the GC3 Panel.
Alarms cannot be canceled or silenced using a keyfob.
7 Remote Control Proprietary &Confidential
49 Copyright © 2015 Nortek Security &Control LLC
To Next Page
Loading...
Need help?
General
