2gig Technologies GC3 User Manual

Figure 4 Sounds Screen
4. Swipe up or down to move the desired sound control into view.
5. Touch and hold the desired control and then swipe to the left to
lower the volume or swipe to the right to raise the volume:
Voice &Chime
Doorbells
Keypad
System Annunciation
6.
Tap t when finished.
Bypass Sensors
You can manually bypass a sensor using the Bypass Sensors button in
the System Settings menu. When you need to bypass one or more
perimeter or interior sensors, it is most common to manually bypass the
sensor. There is also an alternate method for bypassing a sensor called
Force Bypassing. See "Force Bypassing" on page 32.
NOTE: This feature is PIN-protected. To use this feature,
you must know the four-digit Master User Code.
Manually Bypassing a Sensor
When manually bypassing a sensor, tap the Bypass Sensors option in
the System Settings menu to add the desired sensors to the Bypassed
Sensors list.
WARNING!! A bypassed burglary protection sensor does
NOTprovide security protection when the system is armed.
See "Bypassing Open Sensors" on page1.
1. At the Home screen, tap System Settings.
Figure 5 Home Screen—System Settings Button
2. At the Enter Your Code to Access the System Settings
screen, enter an active, four-digit user code.
Figure 6 Enter Your Code to Access the System Settings
3. At the System Settings menu, tap Bypass Sensors.
Figure 7 System Settings >Bypass Sensors
4. On the desired slide control, swipe right to add the sensor to the
system's list of Bypassed Devices.
Figure 8 Bypassed Sensors Screen
5.
Tap t to return to the System Settings menu.
6.
Tap t to return to the Home screen.
The system bypasses the devices and its status changes to
System Ready To Arm (BYPASS).
10 SystemSettings Proprietary &Confidential
67 Copyright © 2015 Nortek Security &Control LLC

2gig Technologies GC3 Specifications

General

Brand	2gig Technologies
Model	GC3
Category	Security System
Language	English