B
COMMAND LINE REFERENCE
This appendix describes how to use Telnet and the serial port (RS232) to
access the command line interface (CLI) for configuration. It also provides
a complete list of all commands that can be executed at the CLI. You can
use the CLI to create scripts that automate basic configuration changes.
Use the CLI to configure the Access Point only if you are an advanced user
with previous experience in using the command interface. Incorrect
commands executed at the CLI may delete the settings on the Access
Point.
Connecting to the
CLI via Telnet
To use Telnet session to gain access to the CLI, the computer that you are
using must have a TCP/IP stack. This computer can be on either the wired
or wireless local network.
To connect to the CLI via Telnet:
1 From the command prompt, telnet to the Access Point’s IP address. For
example, if the Access Point is using its default IP address
(192.168.0.228), enter
Telnet 192.168.0.228.
A prompt appears for the user name and password.
2 Enter your logon name and password. These are the same as the user
name and password that you use for the Web interface.
The default user name is
admin, and the default password is password.
Once connected, you can use any of the commands listed in “
Command
Reference” starting on page 108.
To Next Page
Loading...
