110 APPENDIX B: COMMAND LINE REFERENCE
get config Display current AP configuration
get countrycode Display country code
get ctsmode Display CTS mode
get ctsrate Display CTS rate
get ctstype Display CTS type
get domainsuffix Display domain name server suffix
get dtim Display data beacon rate (DTIM)
get enableANI Display adaptive noise immunity control on/off
get encryption Display encryption mode
get extendedchanmode Display extended channel mode
get firStepLvl Display ANI parameter for FirStepLevel
get fragmentthreshold Display fragment threshold
get frequency Display radio frequency (MHz)
get gateway Display gateway IP address
get gbeaconrate Display 11g beacon rate
get gdraft5 Display 11g draft 5.0 compatibility
get groupkeyupdate Display group key update interval (in seconds)
get hardware Display hardware revisions
get hostipaddr Display host IP address
get ipaddr Display IP address
get ipmask Display IP subnet mask
get keyentrymethod Display encryption key entry method
get keysource Display source of encryption keys
get login Display logon user name
get minimumrate Display minimum rate
get nameaddr Display IP address of name server
get nf Display noise floor
get noiseImmunityLvl Display ANI parameter for noise immunity level
get ofdmTrigHigh Display higher trigger threshold for OFDM phy
errors for ANI control
get ofdmTrigLow Display lower trigger threshold for OFDM phy
errors for ANI control
get ofdmWeakSigDet Display ANI parameter for OFDM weak signal
detection
Table 24 Console Commands
Command Description
To Next Page
Loading...
