114 APPENDIX B: COMMAND LINE REFERENCE
help Display CLI command list
Lebradeb Disable reboot during radar detection
ls List directory
mem System memory statistics
np Network performance
ns Network performance server
ping Ping
radar! Simulate radar detection on current channel
reboot Reboot Access Point
rm Remove file
run Run command file
quit Log off
set 11gonly Set 11g only allowed
set 11goptimize Set 11g optimization level
set 11goverlapbss Set overlapping BSS protection
set acl Set access control list
set aging Set aging interval
set antenna Set antenna
set authentication Set authentication type
set autochannelselect Set auto channel selection
set basic11b Set use of basic 11b rates
set basic11g Set use of basic 11g rates
set beaconinterval Modify beacon interval
set burstSeqThreshold Set maximum number of frames per burst
set burstTime Set burst time
set calibration Set calibration period
set cckTrigHigh Set higher trigger threshold for CCK phy errors for
ANI control
set cckTrigLow Set lower trigger threshold for CCK phy errors for
ANI control
set cckWeakSigThr Set ANI parameter for CCK weak signal detection
threshold
set channel Set radio channel
set cipher Set cipher
Table 24 Console Commands
Command Description
To Next Page
Loading...
