56 CHAPTER 3: CONFIGURING THE ACCESS POINT
Figure 28 PTMP AP List Screen
For increased security, you can restrict the access points that can bridge
with the OfficeConnect Wireless Access Point. To do this:
1 Under the Bridge Mode section of the Basic tab, select the In PTMP mode,
only allow specified APs check box.
2 Click Set PTMP APs. The PTMP AP List screen appears.
3 Type the MAC addresses of the access points that you want to bridge
with the OfficeConnect Wireless Access Point. You can specify up to
eight access points.
4 Click Save.
To Next Page
Loading...
