User’s Manual
Enterprise Access Point ENGLISH
Copyright © 4IPNET, INC. All rights reserved.
Please follow the steps mentioned below to install the hardware of OWL530 / OWL620 / OWL630:
Step 1. Connect an antenna to the Access Point’s antenna connector.
Step 2. Connect the Ethernet Port of OWL530 / OWL620 / OWL630 to the POWER & DATA OUT Port of a
802.3af/at PSE device.
Step 3. Connect one end of an Ethernet cable to the Data In Port of PSE and the other end to the computer.
Step 4. Power on the PSE in order to supply adequate power to the OWL530 / OWL620 / OWL630.
Now, the Hardware Installation is complete.
Please use only the power adapter supplied with the package. Using a different power
adapter may damage this system.
To verify the wired connection between the AP and your switch / router / hub, please also
check the LED status indicator of the respective network devices.
To Next Page
Loading...
