65
M512-3 Juggler : User Guide
© 2021 7thSense
Juggler Properties
Canvas
Select from list of Canvas names created (there may be only 1). Applies to all video channels of
the Juggler (same setting as in the Juggler title bar in the Nodes panel).
Warp Mode
There are two current versions of Juggler firmware: warp and blend or windowing. For warp
and blend units there are 3 warp modes: 1 × 4, 2 × 2, 4 × 1 (this X-Y orientation setting has to
match supplied warp files). Warp Mode describes how the four input channels into the
particular Juggler unit should be interpreted. Defining the arrangement of the source channels
allows an output to span across multiple inputs.
WarpZonePixels / WarpZoneLines
(Applies to warp and blend firmware version only.) Provides a mechanism to override the size
of the input Warp Zones (i.e. the video feed into each Video Channel). If this is left at zero then
Juggler will use the incoming video resolution of Video Channel:1 to determine the correct size
– however, this can cause issues if the video is not present when the warp is being calculated.
Note: All Warp Zones must be the same size.
Uptime
Total time continuous running of the Juggler FPGA since last restart.
System Pixel Format
Select as appropriate.
System Bits Per Pixel
Select as appropriate.
ATOM Properties
For reference only, software and firmware configuration versions installed on the internal ATOM CPU
running the Juggler.
Inputs and Outputs
Properties for each type of input and output are described separately. The types available depend on
the particular build configuration of each Juggler.
System Monitor
Includes internal temperature monitoring of the Juggler module.
To Next Page
Loading...
Need help?
General