Ordering data
Order No. Scope of delivery
1SAP 801 000 R0061 CPU: 07KT94-ARC-AD
1SAP 801 400 R0060 CPU: 07KT98-ARC-AD
1SAP 801 100 R0062 CPU: 07KT98-ARC-DP-AD
1SAP 801 200 R0067 CPU: 07KT98-ARC-ETH-AD
1SAP 801 300 R0072 CPU: 07KT98-ETH-DP-AD
1SAP 801 500 R0062 CPU: 07KT98-ARC-ETH-DP-AD
1.4.1.3.5 ARCNET coupler
Central units with integrated ARCNET coupler (Attached Resource Computer Network):
● 07KT94-ARC-AD
● 07KT98-ARC-AD
● 07KT98-ARC-DP-AD
● 07KT98-ARC-ETH-AD
● 07KT98-ARC-ETH-DP-AD
Technical data
In the replacement device, addresses cannot be set via DIP switch. Instead, the ARCNET inter-
face is configured in the Automation Builder. The ARCNET address can also optionally be set
via the display.
Data Value
Connector ARC (BNC connector)
ARCNET interface For coaxial cable connection
Recommended system cable Cable RG 62 A/U (characteristic impedance
93 Ω)
Cable length 300 m in case of ARCNET bus
with 8 stations. For further information, please
refer to the AC500 documentation (chapter
ARCNET).
Signaling Indication on CPU display
Electrical isolation Yes
Fig. 18
ARCNET short description
The ARCNET interface is configured in the Automation Builder. For further information on the
ARCNET interface for the respective CPU, please refer to the AC500 documentation.
ARCNET system
The general information about the ARCNET system is still valid. For further information on
ARCNET, please refer to the AC500 documentation.
Replacement devices: CPU > Replacement device 07KT9x-AD
2018/09/243ADR010122, 8, en_US54
To Next Page
Loading...
