This document adds the following points to the still valid existing documentation:
● Unavoidable device deviations, e.g. due to technical limitations.
● Expansion of documentation as a result of normative requirements.
● Additional contents not described in the existing documentation.
Further information on replacement device 07DC92-AD can be found in the operating and
assembly instructions of device 07DC92-AD: 3ADR020151M0401. Please note that no separate
operating and assembly instructions are available for device 07DC92.
Please also observe the system data as well as the information on CS31 bus
Ä
Chapter 1.3
“System data and CS31 bus system data” on page 4.
1.5.2.1 Device configuration
Fig. 46: 3ADR333196F0015_07DC92-AD_Front
No. Description
1 Connector X1: CS31 bus
2 Connector X2: 8 DC + voltage supply (incl. DO524)
3 Connector X3: 8 DC + voltage supply (incl. DO524)
4 Hole for screw mounting (screw diameter 4 mm, extension torque 1.2 Nm)
5 Status LEDs for DO524
6 DIP switch for address setting (ADDR)
7 Connector X6: 8 DC + voltage supply (incl. DO524)
8 Connector X5: 8 DC + voltage supply (incl. DO524)
9 Connector X4: Voltage supply (incl. DO524)
10 Ventilation
11 TA525: Label
12 4 LEDs to display the status of the complete 07DC92-AD device
Replacement devices: I/O modules > Replacement device 07DC92-AD
2018/09/24 3ADR010122, 8, en_US 73
To Next Page
Loading...
