Parameters 163
Summary of parameter groups
Group Contents Page
01 Actual values Basic signals for monitoring the drive. 165
03 Input references Values of references received from various sources. 168
04 Warnings and faults Information on warnings and faults that occurred last. 169
05 Diagnostics Various run-time-type counters and measurements related to drive
maintenance.
170
06 Control and status words Drive control and status words. 173
07 System info Drive hardware and firmware information. 178
10 Standard DI, RO Configuration of digital inputs and relay outputs. 179
11 Standard DIO, FI, FO Configuration of the frequency input. 187
12 Standard AI Configuration of standard analog inputs. 188
13 Standard AO Configuration of standard analog outputs. 193
19 Operation mode Selection of local and external control location sources and
operating modes.
198
20 Start/stop/direction Start/stop/direction and run/start/jog enable signal source
selection; positive/negative reference enable signal source
selection.
200
21 Start/stop mode Start and stop modes; emergency stop mode and signal source
selection; DC magnetization settings.
209
22 Speed reference selection Speed reference selection; motor potentiometer settings. 217
23 Speed reference ramp Speed reference ramp settings (programming of the acceleration
and deceleration rates for the drive).
226
25 Speed control Speed controller settings. 230
26 Torque reference chain Settings for the torque reference chain. 235
28 Frequency reference chain Settings for the frequency reference chain. 240
30 Limits Drive operation limits. 251
31 Fault functions Configuration of external events; selection of behavior of the drive
upon fault situations.
258
32 Supervision Configuration of signal supervision functions 1…6. 266
34 Timed functions Configuration of the timed functions. 273
35 Motor thermal protection Motor thermal protection settings such as temperature
measurement configuration, load curve definition and motor fan
control configuration.
280
36 Load analyzer Peak value and amplitude logger settings. 291
37 User load curve Settings for user load curve. 292
40 Process PID set 1 Parameter values for process PID control. 295
41 Process PID set 2 A second set of parameter values for process PID control. 309
43 Brake chopper Settings for the internal brake chopper. 312
44 Mechanical brake control Configuration of mechanical brake control. 314
45 Energy efficiency Settings for the energy saving calculators. 315
46 Monitoring/scaling settings Speed supervision settings; actual signal filtering; general scaling
settings.
319
47 Data storage Data storage parameters that can be written to and read from
using other parameters’ source and target settings.
322
To Next Page
Loading...
