Introduction to the manual 13
Terms and abbreviations
Term/abbre-
viation
Definition
AC 800M Type of programmable controller manufactured by ABB.
ACS800 A product family of ABB drives
ACS-AP-I Types of control panel used with ACS860 drives
ACS-AP-W
AI Analog input; interface for analog input signals
AO Analog output; interface for analog output signals
BCU Type of control unit used in ACS860 drive systems, primarily those with
parallel-connected inverter or supply modules.
DC link DC circuit between rectifier and inverter
DDCS Distributed drives communication system; a protocol used in communication
between ABB drive equipment
DI Digital input; interface for digital input signals
DIO Digital input/output; interface that can be used as a digital input or output
DO Digital output; interface for digital output signals
Drive Frequency converter for controlling AC motors. The drive consists of a rectifier
and an inverter connected together by the DC link. In drives up to
approximately 500 kW, these are integrated into a single module (drive
module). Larger drives typically consist of separate supply and inverter units.
The ACS860 primary control program is used to control the inverter part of the
drive.
DriveBus A communication link used by, for example, ABB controllers. ACS860 drives
can be connected to the DriveBus link of the controller. See page 34.
Vector Control See page 36.
EFB Embedded fieldbus interface. See page 383.
FBA Fieldbus adapter
FCAN-01 Optional CANopen adapter
FDCO-0x Optional DDCS communication module
FDNA-01 Optional DeviceNet
™ adapter
FEN-01 Optional TTL encoder interface module
FEN-31 Optional HTL encoder interface module
FENA-11 Optional Ethernet/IP, Modbus/TCP and PROFINET IO adapter
FENA-21 Optional dual-port Ethernet/IP, Modbus/TCP and PROFINET IO adapter
FEPL-02 Optional POWERLINK adapter
FPBA-01 Optional PROFIBUS DP adapter
FSCA-01 Optional Modbus/RTU adapter
HTL High-threshold logic
ID run Motor identification run. During the identification run, the drive will identify the
characteristics of the motor for optimum motor control.
To Next Page
Loading...
