Parameters 233
36.46 AL2 60 to 70% Displays the percentage of samples recorded by amplitude
logger 2 that fall between 60 and 70%.
0.00%
0.00 … 100.00% Amplitude logger 2 samples between 60 and 70%. 1 = 1%
36.47 AL2 70 to 80% Displays the percentage of samples recorded by amplitude
logger 2 that fall between 70 and 80%.
0.00%
0.00 … 100.00% Amplitude logger 2 samples between 70 and 80%. 1 = 1%
36.48 AL2 80 to 90% Displays the percentage of samples recorded by amplitude
logger 2 that fall between 80 and 90%.
0.00%
0.00 … 100.00% Amplitude logger 2 samples between 80 and 90%. 1 = 1%
36.49 AL2 over 90% Displays the percentage of samples recorded by amplitude
logger 2 that exceed 90%.
0.00%
0.00 … 100.00% Amplitude logger 2 samples over 90%. 1 = 1%
36.50 AL2 reset date Displays the date on which amplitude logger 2 was last reset. -
- Last reset date of amplitude logger 2. -
36.51 AL2 reset time Displays the time at which amplitude logger 2 was last reset. -
- Last reset time of amplitude logger 2. -
37
44 Mechanical brake
control
Configuration of mechanical brake control.
See also section Mechanical brake control (page 57).
44.01 Brake control status Displays the mechanical brake control status word.
This parameter is read-only.
-
0000h…FFFFh Mechanical brake control status word. 1 = 1
44.02 Brake torque
memory
Displays the torque (in percent) at the instant of the previous
brake close command.
This value can be used as a reference for the brake open
torque. See parameters 44.09 Brake open torque source and
44.10 Brake open torque.
A filtering time for this value can be defined using 44.21 Filter
time brake torque memory.
-
-1600.0 … 1600.0% Torque at brake closure. See par.
46.03
No. Name/Value Description Def/FbEq16
Bit Name Information
0 Open command Close/open command to brake actuator (0 = close, 1 = open).
Connect this bit to desired output.
1 Opening torque
request
1 = Opening torque requested from drive logic
2 Hold stopped
request
1 = Hold requested from drive logic
3 Ramp to stopped 1 = Ramping down to zero speed requested from drive logic
4 Enabled 1 = Brake control is enabled
5 Closed 1 = Brake control logic in BRAKE CLOSED state
6 Opening 1 = Brake control logic in BRAKE OPENING state
7 Open 1 = Brake control logic in BRAKE OPEN state
8 Closing 1 = Brake control logic in BRAKE CLOSING state
9…15 Reserved
To Next Page
Loading...
