Parameters 101
04.41 Event word 1 bit 0
code
Selects the hexadecimal code of an event (warning, fault or
pure event) whose status is shown as bit 0 of 04.40 Event
word 1. The event codes are listed in chapter Fault tracing
(page 343).
0000h
0000h…FFFFh Code of event. 1 = 1
04.42 Event word 1 bit 0
aux code
Specifies an auxiliary code for the event selected by the
previous parameter. The selected event is indicated by the
event word only if its auxiliary code matches the value of this
parameter.
With a value of 0000 0000h, the event word will indicate the
event regardless of the auxiliary code.
0000 0000h
0000 0000h …
FFFF FFFFh
Code of warning, fault or pure event. 1 = 1
04.43 Event word 1 bit 1
code
Selects the hexadecimal code of an event (warning, fault or
pure event) whose status is shown as bit 1 of 04.40 Event
word 1. The event codes are listed in chapter Fault tracing
(page 343).
0000h
0000h…FFFFh Code of event. 1 = 1
04.44 Event word 1 bit 1
aux code
Specifies an auxiliary code for the event selected by the
previous parameter. The selected event is indicated by the
event word only if its auxiliary code matches the value of this
parameter.
With a value of 0000 0000h, the event word will indicate the
event regardless of the auxiliary code.
0000 0000h
0000 0000h …
FFFF FFFFh
Code of warning, fault or pure event. 1 = 1
…… … …
04.71 Event word 1 bit 15
code
Selects the hexadecimal code of an event (warning, fault or
pure event) whose status is shown as bit 15 of 04.40 Event
word 1. The event codes are listed in chapter Fault tracing
(page 343).
0000h
0000h…FFFFh Code of event. 1 = 1
04.72 Event word 1 bit 15
aux code
Specifies an auxiliary code for the event selected by the
previous parameter. The selected event is indicated by the
event word only if its auxiliary code matches the value of this
parameter.
With a value of 0000 0000h, the event word will indicate the
event regardless of the auxiliary code.
0000 0000h
0000 0000h …
FFFF FFFFh
Code of warning, fault or pure event. 1 = 1
05
05 Diagnostics
Various run-time-type counters and measurements related to
drive maintenance.
All parameters in this group are read-only unless otherwise
noted.
05.01 On-time counter On-time counter. The counter runs when the drive is powered. -
0…65535 d On-time counter. 1 = 1 d
05.02 Run-time counter Motor run-time counter. The counter runs when the inverter
modulates.
-
0…65535 d Motor run-time counter. 1 = 1 d
No. Name/Value Description Def/FbEq16
To Next Page
Loading...
