Ordering information 307
For the dimension drawings, see section BCU control unit on page 388.
The following option module is to be installed on the BCU control unit and must be ordered
separately:
• RDCO-04C DDCS communication option module (ordering code: 68882915).
Fiber optic cables
See page 186.
Control circuit plug connectors
See page 187.
Kits for 2×D8T supply modules
In Rittal installations, 4×D8T supply consists of two 2×D8T supply module cubicles. In
generic installations, 4×D8T supply consists of two 2×D8T supply module cubicles.
See pages 280…286.
Main switch-disconnectors and main circuit breakers
You must equip the electric supply of a machinery with a main disconnecting device
(IEC/EN60204-1). The main power line is equipped with a main switch-disconnector or a
main circuit breaker [Q1]. This section lists suitable main switch-disconnectors/main circuit
breakers.
Note: For some of the IEC high power units, you can use withdrawable main circuit
breaker instead of the main switch-disconnector. In the table below, these high power units
are marked with *.
The main switch-disconnector kit contains:
• main switch-disconnector unit
• handle with on/off indication
• shaft
• 1 × normally-open auxiliary contact.
ACS880-04-… Main switch-disconnector (IEC) Qty Ordering code Shaft
Type Data Type Dimensions
D
mm
L
mm
U
N
= 690 V (Range 525 … 690 V)
2300A-7+A004* SWITCH KIT OT-
TYPE IEC 2000 E12
2000 A,
1000 V, 55 kA
2 3AXD50000006186 OXP12X465 12 465
Shaft dimensions
D Shaft diameter
L Shaft length
To Next Page
Loading...
