ABB ControlMaster CM10 - PC Configuration

ControlMaster CM10, CM30 and CM50
Universal process controllers,
1
/8,
1
/4 and
1
/2 DIN 9 PC Configuration
IM/CM/S–EN Rev. R 107
9 PC Configuration
In addition to local configuration via the front panel keys, the controller can be configured from a PC via the
infrared port using the ConfigPilot PC configuration software. The controller's infrared port is activated when
accessing the following page in the Advanced level:
Advanced>Device Setup>IrDA Configuration>Connect
Fig. 9.1 PC Configuration via IrDA Service Port
Infrared Port
on Controller
Infrared USB Adaptor