ControlMaster CM10, CM30 and CM50
Universal process controllers,
1
/8,
1
/4 and
1
/2 DIN 7 Advanced Level
IM/CM/S–EN Rev. R 71
7.6.4 Profile Parameters
Common Settings
SPT Start Condition A start condition shall be specified for each control loop that determines the initial start setpoint
of the program.
Program Setpoint The program will start at the setpoint configured by Setpoint Start parameter.
Local Setpoint The program will start from the current local setpoint value.
Current PV The program will start from the current process variable value.
Applies only if the first segment is a ramp.
To Next Page
Loading...
Need help?
General
