ABB ControlMaster CM10 User Manual

ControlMaster CM10, CM30 and CM50
Universal process controllers,
1
/8,
1
/4 and
1
/2 DIN Appendix B – Error Codes
IM/CM/S–EN Rev. R 121
B.2 Profile Error Codes
Error
Code
Error Description
1 Jump Target Invalid
Current active program is
configured to jump to another
program, upon the completion
of this action it is found that
the next program has been
configured incorrectly.
2 Retort Rampback Invalid
Retort Rampback value is a
negative number and must be
changed.
3 Retort Previous Invalid
There is no previous segment
therefore the program is
unable to jump back to the
last ramp rate.
4 PV Invalid
The Process Variable has
failed.
5 Local Setpoint has Failed
The Local setpoint has
become invalid. This may be
that it has travelled outside of
its permissible limits.
9 Validation
The current program is
configured incorrectly and
therefore judged invalid by the
software validation.
Error
Code
Error Description

ABB ControlMaster CM10 Specifications

General

Brand	ABB
Model	ControlMaster CM10
Category	Controller
Language	English