ControlMaster CM10, CM30 and CM50
Universal process controllers,
1
/8,
1
/4 and
1
/2 DIN 10 Specification
IM/CM/S–EN Rev. R 109
Control parameters
Setpoints
Autotune
On-demand calculation of control settings
Process alarms
* 3 sets of PID parameters when used with Gain Scheduling facility
Acknowledgement
Via front panel keys or digital signals
Real-time alarms **
Bank control **
Math blocks **
Delay timers **
** Functionality level 'Standard' and above only
Proportional band * 0.0 to 999.9 %
Integral * 0 to 10000 s
Derivative * 0.0 to 999.9 s
Manual Reset 0.0 to 100.0 %
Local
CM10 2, selectable via digital inputs or front panel
CM30 / CM50 4, selectable via digital inputs or front panel
Remote selectable via digital input or front panel
keys
Number 8
Types High / Low process and High / Low latch
Source Fully configurable (for example, PV, analog
input, math block inbuilt, OP control loop
deviation)
Hysteresis Level and time
Alarm enable Enable / disable of individual alarms via a
digital signal
Number 2
Programmable Time
Day
Duration
Number of outputs 6
Wear levelling Rotate or FIFO
Number 8
Operators +, –, x , /
Average, Maximum, Minimum
High / Low / Median Select
Square root
Multiplexer
Number 2
Programmable Delay
Duration
To Next Page
Loading...
