ABB ControlMaster CM10 User Manual

Language
Operator Templates
Page 1 (4) Template
Operator Functions
Autoscroll
Soft Key Function
Auto Manual Enable
Local Remote Enable
Alarm Ack. Enable
SP Adjust Enable
Settings
Brightness
Contrast*
Date & Time
Date Format
Time & Date
Daylight Saving
SP Adjust Enable
Analog Inputs
Anlg Input 1 (4)
Analog Outputs
Analog Output 1 (2)
Digital I/O
Digital IO 1 (6)
Relays
Relay 1 (4)
Loop 1 Setpoints
Low Limit
High Limit
No. of Local SP’s
Local Setpoint 1
Track Mode
RSP Ratio
RSP Bias
RSP Fault Action
Default Setpoint
Ramp Mode
Ramp Rate
Select Sources
Loop 1 Control
Control Type
Control Action
On/Off Hysteresis
Autotune
PID
Loop 1 Output
Limits
Failure Actions
A/M Select Sources
Slew Rate
Tracking
Loop 1 Split O/P
Min Input 1
Min OP 1
Max Input 1
Max OP 1
Min Input 2
Min OP 2
Max Input 2
Max OP 2
Loop 1 Time Prop
Cycle Time 1
Cycle Time 2
Basic Device Setup Display Input/Output Control
Menu
Menu
Menu
Exit Select Exit Select
Exit Select Exit Select Exit Select
Initial Setup
App. Template
Loop 1 Output Type
Loop 1 Split O/P
Instrument Tag
Mains Freq.
Config Action
Custom Template
Reset to Defaults
Security Setup
Basic Password
Advanced Password
Reset Passwords
Custom Config
Note. When in Advanced Level (configuration) mode, press and hold the key to return to the standard Operator page – see Fig. 3.1, page 5
*Enabled for CM30 and CM50 only
Refer to Section 7.2, page 39 Refer to Section 7.3, page 43 Refer to Section 7.4, page 51Refer to Section 6, page 27 Refer to Section 7.1, page 36
Menu Menu
See
Back
Cover
Loop 1 Setpoints
Local Setpoint 1 (4)
RSP Ratio
RSP Bias
Ramp Mode
Ramp Rate
Loop 1 Control
On/Off Hysteresis
Mode
Autotune
PID
Loop 1 Mot Valve
Ratio
Bias
Deadband
Travel Time
Loop 1 Time Prop
Cycle Time 1
Cycle Time 2
Alarm 1 (8)
Trip

ABB ControlMaster CM10 Specifications

General

Brand	ABB
Model	ControlMaster CM10
Category	Controller
Language	English