ControlMaster CM10, CM30 and CM50
Universal process controllers,
1
/8,
1
/4 and
1
/2 DIN 5 Operator Level Menus
IM/CM/S–EN Rev. R 23
Autotune Used to start or stop an autotune routine. This menu is enabled only if Autotune mode
is On – see page 29.
Adjust Enables a value to be adjusted using the / keys.
The icon next to a value indicates the current adjustable selection.
Setpoint Select Selects the local setpoint to be used (displayed only if more than 1 local setpoint is
configured).
Alarm Acknowledge Acknowledges any active but unacknowledged alarms.
View Select Selects the Operator view to be displayed.
Enter Advanced Level Displays the Access Level selection views – see Section 5.4, page 26 for security options.
Table 5.1 Operator Level Menu Functions
To Next Page
Loading...
Need help?
General
