ABB ControlMaster CM10 - 1.3 Health & Safety; Introduction; 2.1 EC Directive 89; 336; EEC; 2.2 End of Life Disposal

ControlMaster CM10, CM30 and CM50
Universal process controllers,
1
/8,
1
/4 and
1
/2 DIN Contents
2 IM/CM/S–EN Rev. R
7 Advanced Level ........................................................ 36
7.1 Device Setup ....................................................... 36
7.2 Display ................................................................ 39
7.3 Input/Output ........................................................ 43
7.4 Control ................................................................ 51
7.5 Process Alarm ..................................................... 63
7.6 Profile .................................................................. 66
7.6.1 Ramp Types .............................................. 67
7.6.2 Guaranteed Ramp / Soak .......................... 68
7.6.3 Set Point Start Condition – Current PV ...... 70
7.6.4 Profile Parameters ..................................... 71
7.7 Functions ............................................................ 80
7.8 Communication ................................................... 93
7.9 Diagnostics .......................................................... 94
7.9.1 Diagnostic Messages ................................ 96
7.10 Device Info ....................................................... 100
8 Templates and Functionality .................................. 101
8.1 Basic Templates ............................................... 101
8.1.1 Single Loop / Single Loop with
Remote Setpoint ..................................... 101
8.2 Standard Templates ......................................... 103
8.2.1 Auto / Manual Station (Low Signal
Selection / Digital Signal Selection) .......... 103
8.2.2 Analog Backup Station (Low Signal
Selection / Digital Signal Selection) .......... 104
8.2.3 Single Indicator ....................................... 106
8.2.4 Dual Indicator ......................................... 106
9 PC Configuration ..................................................... 107
10 Specification ..........................................................108
Appendix A – Digital and Analog Sources .................116
A.1 Digital Sources ...................................................116
A.2 Analog Sources .................................................117
Appendix B – Error Codes ..........................................118
B.1 Configuration Error Codes .................................118
B.2 Profile Error Codes .............................................121
Appendix C – Analog Input (Engineering) Units ........122
Appendix D – Output Type Assignments ..................124