ControlMaster CM15 and CMF160
Universal process indicator
1
/8 DIN 7 Advanced Level
44 IM/CM/I–EN Rev. P
7.3 Input/Output
Enables analog and digital inputs / outputs and relays to be configured.
Analog Inputs
Analog Input 1 (2 – CM15)*
Analog Input 1 (4 – CMF160)*
Input Type Input types comprise: Millivolts, Milliamps, Volts, Resistance (Ohms), RTD,
Thermocouple,
Digital volt-free, 24V Digital, Freq. Input, Pulse Input.
Additional Input Type comments:
Digital Volt Free Acts as a digital input.
Freq. Input Sets the maximum frequency and equivalent flow rate in the engineering range 0 to 6
KHz. (A frequency of 0.01 to 6 KHz can be used to create an analog value.)
Pulse Input This parameter counts pulses and is recommended only for use with electromagnetic
flowmeters.
*Analog Input 2 and 4:
Freq Input, Pulse Input and Resistance not available. A Thermocouple input type can be set only if the first
input is set to
Thermocouple.
To Next Page
Loading...
