ControlMaster CM15 and CMF160
Universal process indicator
1
/8 DIN 7 Advanced Level
IM/CM/I–EN Rev. P 55
…Totalizer
Count Direction
Up Totalizer value increases with time.
Down Totalizer value decreases with time.
Units (Totalizer) units are used along with the source's units and engineering range to calculate the
count rate automatically (where possible). Where the units or mode required do not allow this, the
count rate must be calculated manually – see Section 7.5.1, page 57.
Count Rate In Analog mode, this represents the counts (in volume units) / second when the source is at its
engineering high value.
In
Digital, Frequency and Pulse mode (see page 54) this represents the number of totalizer (volume)
units / pulse.
Cutoff The lowest input value (in engineering units) the totalizer stops counting at.
Stop Go Source The source required to stop and start the totalizer. Selection is made on the rising edge:
To Next Page
Loading...
