ControlMaster CM15 and CMF160
Universal process indicator
1
/8 DIN 7 Advanced Level
70 IM/CM/I–EN Rev. P
…Functions
Delay Timer 1 (2) Two delay timers are provided. Each is triggered by the rising edge of its assigned source. An
internal timer is started and, when the timer reaches the set Delay Time, its output goes high for
the On Time that is configured. After the delay time is triggered it ignores further transitions of the
source input until the end of this delay timer cycle (until end of On Time).
Source 1 (2) The source signal used to trigger the delay timer. Trigger occurs on rising edge of the signal – see
Appendix A, page 94 for description of sources.
Delay Time The delay (in seconds) between the trigger received and the output of the delay timer going high.
On Time The amount of time (in seconds) the delay timer output is held in the high state.
To Next Page
Loading...
