ABB i-bus KNX AC/S 1.x.1 Series User Manual

ABB i-bus
®
KNX
Parameters
AC/S 1.x.1 | 2CDC508198D0211 Rev. A 197
Object name
Data type
Operating mode override (slave) DPT 20.102
The module has this output socket if the
Display+set (slave)
option is selected for the
Operating mode
parameter.
Outputs the current overridden HVAC operating mode that can be overridden by a higher operating mode.
Signal value:
0 = Auto
1 = Comfort
2 = Standby
3 = Economy
4 = Building Protection
Window status
DPT 1.019
The module has this output socket if the
Yes
option is selected for the
Window status
parameter.
Outputs the window status.
Signal value:
0 = Closed
1 = Open
Presence detector
DPT 1.018
The module has this output socket if the Yes option is selected for the Presence detector parameter.
Outputs the presence status.
Signal value:
0 = Not occupied
1 = Occupied
Rel. humidity
DPT 5.001
The module has this output socket if the Yes option is selected for the Rel. humidity parameter.
Outputs the relative humidity.
Signal value: 0…100%

ABB i-bus KNX AC/S 1.x.1 Series Specifications

General

Brand	ABB
Model	i-bus KNX AC/S 1.x.1 Series
Category	Controller
Language	English