Required tools and equipment
NoteArticle numberEquipment
Content is defined in section
Standard toolkit for controller on
page 202.
-Standard toolkit
-ESD protective wrist band
Required documents
NoteArticle numberDocument
3HAC076810-008Circuit diagram - OmniCore E10
Removing the drive unit
Preparations
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 28.
1
Location of wrist strap button:
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 41.
2
xx2100001295
Removing the controller top cover on
page 120.
Remove the top cover of the controller.3
Continues on next page
136 Product manual - OmniCore E10
3HAC079399-001 Revision: C
© Copyright 2019-2022 ABB. All rights reserved.
5 Repair
5.2.4 Replacing the drive unit
Continued
To Next Page
Loading...
