Removing the drive unit
Note/IllustrationAction
xx2100001336
Pull the cable ties out from the locking
holes.
Tip
Take photos of the cable ties and locking
holes before pulling out, to have as a
reference when refitting the cable ties.
1
Disconnect:
• X1-T4.X7, T4.X8, T4.X9, T4.X15
• X2-T4.X16
• A2.X13 - G1/G2.X1
• T4.X5 - A1.X4
• T4.X3 - A2.X9
• T4.X1 - A2.X10
2
xx2100001331
Release the fan connector from the
bracket.
3
Continues on next page
Product manual - OmniCore E10 137
3HAC079399-001 Revision: C
© Copyright 2019-2022 ABB. All rights reserved.
5 Repair
5.2.4 Replacing the drive unit
Continued
To Next Page
Loading...
