Note/IllustrationAction
xx2100001336
Insert the cable ties back to the locking
holes.
Tip
Refit the cable ties according to the
photo.
6
Concluding procedure
Note/IllustrationAction
Refitting the controller cover on page 121.Refit the top cover.1
Perform the function tests to verify that
the safety features work properly, see
Function tests on page 110.
2
140 Product manual - OmniCore E10
3HAC079399-001 Revision: C
© Copyright 2019-2022 ABB. All rights reserved.
5 Repair
5.2.4 Replacing the drive unit
Continued
To Next Page
Loading...
