Note/IllustrationAction
xx1900000110
Access the RobotWare Installation Utilit-
ies.
2
Tap Advanced, and then Restore Hard-
ware Settings.
3
The Restore Hardware Settings window
is displayed.
4
Follow the instructions and tap Next to
proceed.
Carefully read the information and then
check all boxes to confirm that you agree
with the ABB conditions. Tap Next to
proceed.
5
xx2000000007
Read the serial number on the front of
the controller and type it in field Serial
Number. Tap Next.
6
The system compares the downloaded file
and the manually entered serial number to
ensure that there is a match.
Tap Browse to open the hardware inform-
ation file from its location. The restoration
of the serial number is completed.
7
146 Product manual - OmniCore E10
3HAC079399-001 Revision: C
© Copyright 2019-2022 ABB. All rights reserved.
5 Repair
5.2.5 Replacing the computer and logic unit
Continued
To Next Page
Loading...
