Note/IllustrationAction
xx2100001339
Remove the attachment screws.3
Take out the incoming mains connector.4
Refitting the incoming mains connector
Refitting the incoming mains connector
Note/IllustrationAction
DANGER
Before doing any work inside the cabinet,
disconnect the mains power. For more
information, see Electrical safety on
page 28.
1
Location of wrist strap button:
ELECTROSTATIC DISCHARGE
(ESD)
The unit is sensitive to ESD. Before
handling the unit read the safety inform-
ation in section The unit is sensitive to
ESD on page 41.
2
xx2100001295
Insert the incoming mains connector into
the front panel of the cabinet.
3
Continues on next page
Product manual - OmniCore E10 155
3HAC079399-001 Revision: C
© Copyright 2019-2022 ABB. All rights reserved.
5 Repair
5.3.2 Replacing the incoming mains connector
Continued
To Next Page
Loading...
