ABB XIO-08 - 7 Additional Procedures; Enable SSHSFTP; Verify or Add Applications on the XIO

XIO USER MANUAL | 2106424MNAA | 115
—
7 Additional procedures
Customize the XIO to meet individual site needs. Complete these steps in PCCU Expert view. Click View
on the PCCU32 menu and select Expert from the drop-down list.
7.1 Enable SSH/SFTP
SSH/SFTP servers require a private key for authentication. The keys are in a protected storage location in
the firmware (flash) and remain unchanged by software updates.
Customer access to the SFTP is read-only. SSH access is not available to the customer. Customers can
copy files from the XIO but cannot write or send files to the XIO.
The following folders are available to copy or download:
– Crash dumps
– Firmware: Main Totalflow application (App), factory startup (cold) configuration, and startup (cold)
configuration
– Logs: System and device loader log files
– tfData: Running (warm) configuration files
IMPORTANT NOTE:
SSH/SFTP services are disabled by default for security. Perform this procedure
only if required and you are an advanced user.
Before enabling, see section 8 Configure security
(recommended)
or contact Technical support.
SSH/SFTP access is TCP/IP based. Enable and configure
Ethernet with valid IP parameters.
To enable the SSH/SFTP services on the XIO:
7.2 Verify or add applications on the XIO
To verify that the installed applications: