XIO USER MANUAL | 2106424MNAA | 123
8.5.1 Configure non-default XIO security code on the RMC
The XIO Interface application requires read and write privileges to work properly with the XIO. If the XIO
security level 2 code (write protection) is non-default, you must configure this code in the XIO Interface
Communications Setup (in the XIO Security Code field). The position of the security switch does not
remove the requirement for the XIO Interface App to be configured for level 2 access.
This procedure configures the XIO level 2 security code in the XIO Interface to allow the RMC to perform
writes on the XIO. Connection failure occurs when the incorrect security code is configured in the XIO
Interface.
This procedure assumes that the XIO level 2 security code has already been configured on the XIO
Station Setup tab, and that the code was recorded for safe keeping. Once configured, the security code
is not visible on the screen. Before proceeding, obtain the correct code.
To configure the security code on the RMC:
Figure 8-4: Configuration of XIO Security code on the XIO Interface
8.6 Configure Role-Based Access Control (RBAC)
Role Based Access Control (RBAC) is a feature in PCCU32 that allows an administrator to designate roles
and control access levels to various applications and processes in the device. The XIO supports RBAC
security files. Each security file is configurable for the specific device type.
When designing an RBAC security system, consider all required user access to the system. Create the
users and an administrator and assign a default role to each.
To Next Page
Loading...
Need help?
General
