ABB XIO-08 - Page 3

XIO USER MANUAL | 2106424MNAA | 3
3.1.4 Mounting requirements .................................................................................... 26
3.1.5 Install antenna (for wireless functionality) ........................................................... 26
3.2 Wiring requirements ..................................................................................................... 26
3.3 Unpack and inspect ...................................................................................................... 26
3.4 Basic hardware installation ............................................................................................ 26
3.4.1 Ground the controller ....................................................................................... 27
3.4.2 Standalone mounting ....................................................................................... 27
3.4.3 Mounting when using an enclosure ..................................................................... 27
3.4.4 Wire serial communication ports ........................................................................ 28
3.4.5 Connect TFIO modules ..................................................................................... 31
3.5 Power the XIO ............................................................................................................. 32
3.5.1 Power-on sequence .......................................................................................... 33
3.5.2 Power with external power source ...................................................................... 33
4 Startup ................................................................................................................................. 35
4.1 Download PCCU32 from the ABB global website ................................................................ 35
4.2 Install PCCU32 ............................................................................................................. 37
4.3 Establish local communication ........................................................................................ 37
4.3.1 Using the USB port .......................................................................................... 37
4.3.2 Using the Ethernet ports ................................................................................... 39
4.4 Change PCCU to Expert view (required) ........................................................................... 42
4.5 Configure basic XIO parameters ..................................................................................... 43
4.6 Configure network communication (4-port switch mode) .................................................... 44
4.6.1 Sample connections ......................................................................................... 44
4.6.2 Configuration overview ..................................................................................... 46
4.6.3 Configure the XIO ............................................................................................ 47
4.6.4 Configure the RMC ........................................................................................... 49
4.7 Configure serial communication applications (COM ports) ................................................... 56
4.7.1 Configure COM port for communication with ABB devices ...................................... 57
4.7.2 Configure XIO application export ....................................................................... 69
4.7.3 Verify XIO application export on the RMC ............................................................ 70
4.7.4 Configure measurement applications to use XIO values ......................................... 72
4.8 Configure Ethernet-Serial Passthrough ............................................................................ 73
4.8.1 Configure the XIO ............................................................................................ 74
4.8.2 Configure the RMC ........................................................................................... 82
4.8.3 Configure the peripheral ................................................................................... 86
4.8.4 Configure measurement applications to use XIO values ......................................... 87
4.9 Configure the I/O Interface for TFIO module support ......................................................... 88
4.9.1 Connect the TFIO modules to the XIO ................................................................. 88
4.9.2 Add and export the I/O Interface application ....................................................... 90
4.9.3 Verify TFIO module detection on XIO .................................................................. 91
4.9.4 Verify I/O interface application export on RMC ..................................................... 95