Machine Maintenance Procedures 3-31
Camera Module Installation 0
1. Connect camera module cable (G) to module connector (H). (Figure 3-28)
2. Turn camera module over.
3. Position camera module at vertical angle. (Figure 3-27)
4. Install camera module (E) into front bezel until clear of latches (F).
5. Align and install camera module to camera bracket.
6. Install and secure screws (D) to camera bracket.
7. Install right function board cable (A) to guides (C) on middle frame. (Figure 3-25)
8. Connect right function board cable to function board connector (B).
9. Install back cover.
ID Size Quantity Screw Type
D M2.0x3.0 2
To Next Page
Loading...
