3-18 Machine Maintenance Procedures
Power Board Removal 0
Prerequisite:
Back cover Removal
1. Locate power board (A) on front bezel. (Figure 3-12)
Figure 3-12. Power Board
2. Disconnect power board cable (B) from power board connector (C).
3. Remove screws (D) from front bezel.
4. Remove power board from guidepins (E) on front bezel.
Power Board Installation 0
1. Align and install power board (A) with guidepins (E) on front bezel. (Figure 3-12)
2. Install and secure screws (D) to front bezel.
3. Connect power board cable (B) to power board connector (C).
4. Install back cover.
ID Size Quantity Screw Type
D M3.0x5.0 2
To Next Page
Loading...
