Machine Maintenance Procedures 3-13
Use caution when lifting or removing back cover to prevent damage to TV tuner
connector.
4. Lift back cover (C) until slots (D) are clear of mainboard connectors, as shown in
Figure 3-8.
Figure 3-8. Back Cover
5. Remove back cover.
Back Cover Installation 0
1. Align slots (D) of back cover (C) with mainboard connectors. (Figure 3-8)
2. Install back cover to front bezel. (Figure 3-6)
3. Press along edges until there is no gap between back cover and front bezel.
4. Install and secure screw (A) to front bezel.
ID Size Quantity Screw Type
M3.0x6.0 1
To Next Page
Loading...
