Acer Aspire Z1100 - Converter Board Installation; Converter Board Removal

3-16 Machine Maintenance Procedures
Converter Board Removal 0
Prerequisite:
Back cover Removal
1. Locate converter board (A) on middle frame. (Figure 3-10)
Figure 3-10. Converter Board
2. Disconnect the following cables:
Converter cable (B) from converter board connector (D)
Change board FFC (E) from converter board connector (F)
3. Remove screws (C) from middle frame.
4. Remove converter board.
Converter Board Installation 0
1. Install converter board (A) to middle frame. (Figure 3-10)
2. Install and secure screws (C) to middle frame.
3. Connect the following cable:
Converter cable (B) to converter board connector (D)
Change board FFC (E) to converter board connector (F)
4. Install back cover.
ID Size Quantity Screw Type
C M3.0x5.0 2
A
B
C
D
C
E
F